Harmann - automation - EHC 1 electric heater controller

manufacturer: Harmann

product #: 32600

Order multiples of: 1 Add to cart

Add to wish list Ask about product Report an error in description Installment purchase is available from 100 PLN of product value or the entire order. Leasing is available from PLN 369 of the value of the product

Price on request

price-list
net unit price
713,00zł
for item
discount price
net unit price
496,25zł
for item
minimum trading quantity
the amount of product
1.00 item
unit
trading
1.00 item
total price
net list price
713,00zł
for 1.00 item
total price
discounted net price
496,25zł
for 1.00 item
price-list
gross unit price
876,99zł
for item
discount price
gross unit price
610,39zł
for item
minimum trading quantity
the amount of product
1.00 item
unit
trading
1.00 item
total price
gross list price
876,99zł
for 1.00 item
total price
gross discount price
610,39zł
for 1.00 item

Product description

The controller has a controller proportional to cooperation with electric air heaters powered by a single-phase (1 ~ 230 V) voltage with a maximum power of 3.2 kW and a two-phase (2 ~ 400 V) with a maximum power of 6.4 kW and a current intensity of up to 16 A.

Technical data

  • controller with proportional controller
  • automatic adaptation to supply voltage
  • detection of connected sensor in
  • degree of protection IP20
  • for wall mounting
  • the device should be connected in series between the power source and the electric heater
  • power to the heaters switched on via a triac at zero phase angle to eliminate interference
  • the operating mode is set with a switch under the housing
  • width 150 mm
  • height 80 mm
  • depth 45 mm
  • maximum temperature 30 C

Modes of operation

  • room temperature control in the range of 0-30 C based on the reading of the built-in temperature sensor (Tint)
  • air supply temperature control in the range of 0-30 C or 0-60 C based on the reading of the temperature sensor TJK10K (Tlimit) located in the duct after the heater
  • room temperature control in the range of 0-30 C based on the reading of two sensor in TJK10K (Tlimit, Texh), in this mode the minimum value (0-20 C) and maximum (25-60 C) of the supply temperature controlled by the sensor Tlimit is set using a potentiometer in MIN / MAX inside the housing

The controller enables activation of the night temperature reduction by means of an external potential-free contact connected to the terminal in the Timer, in the range of 0-10 C (NIGHT potentiometer).

Note: TJK10K sensors must be purchased separately.